Browsed by
Tag: lab

Activity: Routing Configuration in Packet Tracer

Activity: Routing Configuration in Packet Tracer

Comments 242 Comments

Open the Packet Tracer and drag the devices to the working sheet as shown in the figure below. Assign the IP address to every device as shown in the figure. Figure: PC ip seating Assign IP addresses to the interfaces of your routers. Use the config terminal command on each router to enter global configuration mode, then use the interface [interface_type] [interface_number] command to access the interface configuration mode. Finally, assign the IP address using the ip address [ip_address] [subnet_mask]…

Read More Read More

Understanding Ethernet Cables in Networking​

Understanding Ethernet Cables in Networking​

Comments 0 Comment

Ethernet cable is a common type of network cable used in wired Ethernet networks. It typically consists of twisted pairs of copper wires that are enclosed in an outer insulating sheath. Ethernet cables come in various categories, such as Cat5e, Cat6, and Cat7, each with different specifications and capabilities to support various network speeds and performance levels.  Ethernet Cables Configuration Ethernet cables come in two primary configurations: straight-through and crossover. The straight-through cable is the more prevalent type and is typically…

Read More Read More

Verified by MonsterInsights