Browsed by
Category: Computer Network Lab

Navigate the world of data communication, network protocols, and architecture using essential tools like Packet Tracer and Wireshark. Whether you’re analyzing network traffic, mastering subnetting, or securing systems, our labs cover widely searched keywords, ensuring a hands-on experience aligned with student needs. Elevate your understanding of Computer Networks with real-world applications, and join us on a journey where Packet Tracer and Wireshark seamlessly integrate into the fabric of network education.

Activity: Routing Configuration in Packet Tracer

Activity: Routing Configuration in Packet Tracer

Comments 324 Comments

Open the Packet Tracer and drag the devices to the working sheet as shown in the figure below. Assign the IP address to every device as shown in the figure. Figure: PC ip seating Assign IP addresses to the interfaces of your routers. Use the config terminal command on each router to enter global configuration mode, then use the interface [interface_type] [interface_number] command to access the interface configuration mode. Finally, assign the IP address using the ip address [ip_address] [subnet_mask]…

Read More Read More

cables connected to ethernet ports
Lab Activity: Switch | VLAN Configuration in Cisco Packet Tracer

Lab Activity: Switch | VLAN Configuration in Cisco Packet Tracer

Comments 373 Comments

The objective of this lab activity is to familiarize students with the basic configuration of a Cisco switch using Cisco Packet Tracer. Students will learn essential switch configuration commands and understand how to set up and manage switch interfaces. Additionally, they will learn how to configure VLANs on packet tracers. Learn more about physical and virtual LANs. Equipment and Software Requirements Topology Setup Basic Switch Configuration Access the Cisco switch CLI or use the graphical interface in Packet Tracer. Configure…

Read More Read More

Introduction to Cisco Packet Tracer – Basics and Installation

Introduction to Cisco Packet Tracer – Basics and Installation

Comments 7 Comments

Welcome to this tutorial on Cisco Packet Tracer, a powerful simulation tool used for network and system modelling. Whether you’re a networking enthusiast, student, or IT professional, understanding the basics of Cisco Packet Tracer is essential for simulating and practising networking scenarios. This tutorial will guide you through the fundamentals of the Cisco Packet Tracer and walk you through the installation process. What is Cisco Packet Tracer? Cisco Packet Tracer is a network simulation tool developed by Cisco Systems. It…

Read More Read More

An In-Depth Study of Network Devices

An In-Depth Study of Network Devices

Comments 50 Comments

Today, we will delve into the world of network devices. These devices are the backbone of modern communication, allowing data to flow seamlessly across local and global networks. We’ll study six essential network devices in detail: Let’s begin with the first device: 1. Repeater 2. Hub 3. Switch 4. Bridge 5. Router 6. Gateway Along with the above devices, a number of other network devices, such as Firewall, Load Balancer, Proxy Server, Access Point, Modem, Content Delivery Network (CDN), VoIP…

Read More Read More

Understanding Ethernet Cables in Networking​

Understanding Ethernet Cables in Networking​

Comments 20 Comments

Ethernet cable is a common type of network cable used in wired Ethernet networks. It typically consists of twisted pairs of copper wires that are enclosed in an outer insulating sheath. Ethernet cables come in various categories, such as Cat5e, Cat6, and Cat7, each with different specifications and capabilities to support various network speeds and performance levels.  Ethernet Cables Configuration Ethernet cables come in two primary configurations: straight-through and crossover. The straight-through cable is the more prevalent type and is typically…

Read More Read More

Verified by MonsterInsights